Removal & Installation (Sebring Sedan & Stratus Sedan - Front)

Disconnect battery. Open door. Disconnect main wiring harness at door opening. If equipped, remove window crank. Disengage clips attaching speaker grille to trim panel. Remove screws attaching door trim panel to door from around speaker opening. Remove screw cap from bottom of armrest pull cup.
Remove screw attaching armrest pull cup to support bracket behind trim panel. Remove screw cap from behind inside door latch handle. Remove screw attaching door latch handle door panel. Disengage clips holding trim panel to perimeter of door.
Lift trim panel upward to disengage upper retainer channel. Tilt top of trim panel away from door. Disengage clip holding latch linkage to back of release handle. Remove door trim panel from vehicle. To install, reverse removal procedure.