Wiper Switch
NOTE:
For complete multifunction switch testing, see MULTIFUNCTION SWITCH under COMPONENT TESTS in STEERING COLUMN SWITCHES - SEBRING CONVERTIBLE, SEBRING SEDAN & STRATUS SEDAN article.
Disconnect wiper switch harness connector. Measure resistance between specified terminals with switch in appropriate position. See WIPER SWITCH RESISTANCE table. See CONNECTOR IDENTIFICATION . If resistance is not as specified, replace multifunction switch.
WIPER SWITCH RESISTANCE
| Switch Position | Between/Connector Terminals No. | Ohms | ||||
|---|---|---|---|---|---|---|
| Wiper | ||||||
| Low | C1 4 & 9 | 1250 | ||||
| High | C1 4 & 9 | 1820 | ||||
| Mist | C1 4 & 9 | 1250 | ||||
| Washer | C1 3 & 9 | (1) | ||||
| Intermittent | ||||||
| 1 | C1 4 & 9 | 11,870 | ||||
| 2 | C1 4 & 9 | 9870 | ||||
| 3 | C1 4 & 9 | 7870 | ||||
| 4 | C1 4 & 9 | 5870 | ||||
| 5 | C1 4 & 9 | 3870 | ||||
| 6 | C1 4 & 9 | 1870 | ||||
|
||||||