Removal & Installation (Sebring Sedan - 2.4L & Stratus Sedan - 2.4L)

NOTE: Power steering pressure switch is not used on Sebring Sedan and Stratus Sedan equipped with a V6 engine.

1. Power steering pressure switch is located on power steering gear assembly. See Fig 1. Disconnect negative battery cable.
2. Raise and support vehicle. Disconnect power steering pressure switch harness connector. Using a crowfoot and a long extension, remove power steering pressure switch.
3. To install, reverse removal procedure. Tighten power steering pressure switch to specification. See TORQUE SPECIFICATIONS .

Fig 1: Locating Power Steering Pressure Switch (2.4L - Sebring Sedan & Stratus Sedan)

Courtesy of DAIMLERCHRYSLER CORPORATION