Instrument Cluster

Press and hold odometer/trip reset button while turning ignition switch to OFF, then RUN position. This will cycle an electronic display segment check and illumination in sequence of all CCD bus activated warning indicators. There are 4 check functions:

1. CHECK 1 (Gauge Display Check)
   
   If all gauges fail to move, replace printed circuit. If any gauge fails to move, replace gauge assembly. If any gauge is not in proper position, replace printed circuit. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.
2. CHECK 2 (Warning Light Display Check)
   
   If any light does not illuminate, check bulb. If bulb is okay, replace printed circuit. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.
3. CHECK 3 (Vacuum Fluorescent (VF) Display Check)
   
   If any VF segment does not illuminate, replace odometer/transmission range indicator. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.
4. CHECK 4 (Transmission Range VF Display, A/T Check)
   
   If any VF segment does not illuminate, replace odometer/transmission range indicator. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.