LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Sebring LX, 2D Convertible >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System - TEVES Mark 20 - Except Coupe >> Removal & Installation >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

  1. Access rear WSS electrical connector in trunk compartment. Disconnect rear WSS electrical connector from vehicle wiring harness.
  2. Raise and support vehicle. Remove rear wheel. Remove grommet retainer from rear frame rail. Carefully remove grommet and WSS cable from vehicle body.
    CAUTION: If rear WSS is stuck in brake caliper adapter plate, use a hammer and soft drift to lightly tap on each side of WSS near bolt area to rotate WSS back and forth until WSS can be removed. DO NOT use pliers to pull WSS from brake caliper adapter plate.
  3. Remove speed sensor routing clips from rear upper control arm and brake flex hose routing bracket. Carefully remove rear WSS from brake caliper adapter.
scientia non olet · About LEMON Manuals