LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Neon R/T >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock - TEVES Mark 20 >> Removal & Installation >> Rear Wheel Speed Sensor (WSS) >> Removal

Rear Wheel Speed Sensor (WSS): Removal

  1. Raise and support vehicle. Remove rear wheel. Disconnect rear WSS electrical connector from vehicle wiring harness.
  2. Remove clip attaching speed sensor cable connector to vehicle body. Remove speed sensor routing bracket from under rear brake flex hose mounting bracket. Remove speed sensor cable from routing clips on rear brake flex hose and chassis brakeline.
    CAUTION: If rear WSS is stuck in brake caliper adapter plate, use a hammer and soft drift to lightly tap on each side of WSS near bolt area to rotate WSS back and forth until WSS can be removed. DO NOT use pliers to pull WSS from brake caliper adapter plate.
  3. Remove rear WSS-to-brake caliper adapter plate bolt. Remove bolt securing speed sensor cable routing bracket to rear strut assembly. Carefully remove rear WSS from brake caliper adapter.
scientia non olet · About LEMON Manuals