LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2001 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Restraints >> Seat Belts >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> General Motors >> Disabling & Activating Air Bag System >> Activating System (Corvette)

Activating System (Corvette)

  1. Remove key from ignition switch. Ensure SDM fuse is still removed from fuse block. Connect passenger air bag 2-pin Yellow connector located at base of steering column. Install CPA clip. Repeat procedure for driver air bag 2-pin Yellow connector. Install CPA clip. Install lower steering column cover.
  2. Install SDM fuse in fuse block. Staying well away from air bag modules, turn ignition switch to ON position. Ensure AIR BAG warning light flashes 7 times, and then turns off.
Fig 1: Locating Driver Air Bag Connector (Corvette)
G98H13554Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating Passenger Air Bag Connector (Corvette)
G98F13552Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals