If Spot Lamp Does Not Light
- If both spot lamps are inoperative, check fuse F (spot lamp master). Refer to SYSTEM WIRING DIAGRAMS for fuse locations. If fuses are OK, refer to Step 4. If fuse(s) are faulty, replace as necessary.
- If the left spot lamp is inoperative, check fuse X. If fuse is OK, refer to Step 4. If fuse is faulty, replace as necessary. If fuse blows again, find short to ground. Refer to SYSTEM WIRING DIAGRAMS for circuit information.
- If the right spot lamp is inoperative, check fuse Y. If fuse is OK, refer to Step 4. If fuse is faulty, replace as necessary. If fuse blows again, find short to ground. Refer to SYSTEM WIRING DIAGRAMS for circuit information.
- Check for B+ power at the spot lamp bulb with switch turned ON (Refer to REMOVAL ). If there is B+ power at the spot lamp bulb connector, replace bulb. If there is not B+ power present, refer to Step 5.
- If there is not B+ power present at the spot lamp with the switch turned on, check circuit for an open. Possibly the connector in the A-pillar. Refer to SYSTEM WIRING DIAGRAMS for circuit information.
- If there is B+ power at the spot lamp connector, and no B+ power at the spot lamp bulb, then the switch is defective within the spot lamp assembly and the entire unit must be replaced. (Refer to REMOVAL ).
- If lamp still does not light, remove the handle (Refer to REMOVAL ), and check the contact on the shaft end of the head assembly into the handle to make sure the contact is not damaged.