Power Brake Booster: Installation

To install, reverse removal procedure. Using Lubricate, cover surface of brake pedal pin. Use NEW push rod retaining clip. Bleed brakes. See BLEEDING BRAKE SYSTEM  . Adjust stoplight switch. See STOPLIGHT SWITCH  under ADJUSTMENTS. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Isolating Remote Ground Cable

Courtesy of CHRYSLER CORP.

Fig 2: Locating EGR Valve Transducer

Courtesy of CHRYSLER CORP.

To install, reverse removal procedure. Using Lubricate, cover surface of brake pedal pin. Use NEW push rod retaining clip and intake manifold gaskets. Bleed brakes. See BLEEDING BRAKE SYSTEM  . Adjust stoplight switch. See STOPLIGHT SWITCH  under ADJUSTMENTS. Tighten all nuts and bolts to specification. See TORQUE SPECIFICATIONS  .