LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Sebring Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Windshield Wiper System >> Wiper Park Switch Failure; Wipers Not Parking In OFF Position (Sebring Convertible)

Wiper Park Switch Failure; Wipers Not Parking In OFF Position (Sebring Convertible)

  1. Turn ignition on. Operate wiper in intermittent mode. Using scan tool, select MONITOR DISPLAY, WIPER SYSTEM and observe wiper park switch. If wiper park switch does not toggle from closed to open, turn wipers off and go to next step. If wiper park switch toggles from closed to open, system is operating properly. Using scan tool, clear trouble codes, and try to reproduce fault.
  2. Turn wipers off. Disconnect wiper motor Light Gray 4-pin connector and ensure connector is clean and not damaged. Using scan tool, continue observing wiper park switch. Connect a jumper wire between ground and wiper motor 4-pin connector terminal "D" (Tan/Red wire). See Figure. If scan tool does not display SWITCH: CLOSED, go to next step. If scan tool displays SWITCH: CLOSED, replace wiper motor. See appropriate WIPER/WASHER SYSTEMS article.
  3. Locate BCM 14-pin connector C1. See Figure. Using a jumper wire, backprobe between ground and BCM 14-pin connector C1 terminal No. 2 (Tan/Red wire). See CONNECTOR IDENTIFICATION . If scan tool does not display SWITCH: CLOSED, go to next step. If scan tool displays SWITCH: CLOSED, repair open in Tan/Red wire. See WIRING DIAGRAMS .
  4. Replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals