Shorted Driver Door Ajar Circuit (Except Sebring Convertible)
- Disconnect left front door ajar switch and ensure connector is clean and not damaged. Using scan tool, read door ajar switch status. If scan tool displays DR DOOR AJAR SW: CLOSED, go to next step. If scan tool does not display DR DOOR AJAR SW: CLOSED, replace left front door ajar switch.
- Disconnect Body Control Module (BCM) 20-pin connector C5 at junction block and ensure connector is clean and not damaged. Using scan tool, read door ajar switch status. If scan tool displays DR DOOR AJAR SW: CLOSED, replace BCM. See BODY CONTROL MODULE (BCM) under REMOVAL & INSTALLATION. If scan tool does not display DR DOOR AJAR SW: CLOSED, repair short to ground in Tan wire between driver's door ajar switch and BCM. See WIRING DIAGRAMS .