LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Sebring Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Door Ajar >> Open Passenger Door (Left Rear) Ajar Circuit; Courtesy Light Inoperative With Left Rear Door (Except Sebring Convertible)

Open Passenger Door (Left Rear) Ajar Circuit; Courtesy Light Inoperative With Left Rear Door (Except Sebring Convertible)

  1. Disconnect left rear door ajar switch and ensure connector is clean and not damaged. Connect a jumper wire between ground and left rear door ajar switch connector (Tan/Red wire). See WIRING DIAGRAMS . Using scan tool, read door ajar switch status. If scan tool does not display PASS AJAR: CLOSED, go to next step. If scan tool displays PASS AJAR: CLOSED, replace left rear door ajar switch.
  2. Ensure left rear door ajar switch ground strap is clean and not damaged. Repair or replace ground strap as necessary. If ground strap is okay, go to next step.
  3. Disconnect jumper wire. Locate BCM 20-pin connector C5 at junction block. See Figure. Connect a jumper wire between ground and BCM 20-pin connector C5 terminal No. 6 (Tan/Red wire). See CONNECTOR IDENTIFICATION . Using scan tool, read door ajar switch status. If scan tool does not display PASS AJAR: CLOSED, go to next step. If scan tool displays PASS AJAR: CLOSED, repair open in Tan/Red wire.
  4. Disconnect BCM 20-pin connector C5 at junction block and ensure connector is clean and not damaged. Check BCM 20-pin connector C5 terminal No. 6 for damage. If terminal is damaged, repair as necessary. If terminal is okay, replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals