LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Sebring Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules - Except Coupe >> System Tests >> Door Ajar >> Open Driver Door (Left Front) Ajar Circuit; Courtesy Light Inoperative With Left Front Door (All Models)

Open Driver Door (Left Front) Ajar Circuit; Courtesy Light Inoperative With Left Front Door (All Models)

  1. Disconnect left front door ajar switch. Connect a fused jumper between ground and left front door ajar switch connector terminal (Tan wire). See WIRING DIAGRAMS . Using scan tool, read left front door ajar switch status. If scan tool displays LF DOOR AJAR: CLOSED, go to next step. If scan tool does not display LF DOOR AJAR: CLOSED, replace left front door ajar switch.
  2. Ensure left front door ajar switch connector is clean and not damaged. Ensure left front door ajar switch ground strap is clean and not damaged. Repair or replace ground strap as necessary. If ground strap and connector are okay, go to next step.
  3. Disconnect jumper wire. Locate BCM 20-pin connector C5 at junction block. See Figure. DO NOT disconnect connector. Backprobe a jumper wire between ground and BCM 20-pin connector C5 terminal No. 7 (Tan wire). See CONNECTOR IDENTIFICATION . Using scan tool, read left front door ajar switch status. If scan tool displays LF DOOR AJAR: CLOSED, repair open in Tan wire between left front door ajar switch and BCM. If scan tool does not display LF DOOR AJAR: CLOSED, go to next step.
  4. Disconnect BCM 20-pin connector C5 at junction block and ensure connector is clean and not damaged. Check BCM 20-pin connector C5 terminal No. 7 for damage. If terminal is damaged, repair as necessary. If terminal is okay, replace BCM. See BODY CONTROL MODULE (BCM)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals