Fuel Gauge Sending Unit Resistance
Remove rear seat cushion and center protection plate to gain access to fuel gauge sending unit. Remove fuel gauge sending unit from fuel tank. See FUEL GAUGE SENDING UNIT under REMOVAL & INSTALLATION. Using an ohmmeter, measure resistance between fuel gauge terminal and ground terminal with float at points "E" and "F". See Fig 1 and Fig 2 . See FUEL GAUGE SENDING UNIT RESISTANCE table. Ensure resistance changes smoothly when float arm is moved slowly between points "E" and "F". Replace sending unit if readings are not as specified.
FUEL GAUGE SENDING UNIT RESISTANCE
| Measure Point (1) | Resistance (Ohms) | ||
|---|---|---|---|
| F | 2-6 | ||
| E | 105-119 | ||
|
|||