Multiple/Individual Instrument Cluster Gauges Inoperative

1. Remove instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. Turn ignition on. Using DVOM, measure voltage between instrument cluster connector terminal No. 21 (Pink wire) and ground. See Fig 1 . If battery voltage exists, go to next step. If battery voltage does not exist at either or both terminals, repair as necessary.
2. Turn ignition off. Using DVOM, measure resistance between ground and instrument cluster connector terminal No. 10 (Black/Orange wire). If continuity does not exist, repair as necessary. If continuity exists, check for damaged pins or connector. If connector is okay, replace instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION.

Fig 1: Identifying Instrument Cluster Connector Terminals

Courtesy of DAIMLERCHRYSLER CORP.