LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2000 >> Intrepid Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - General Servicing Procedures >> Orifice Tube Replacement >> General Motors >> Removal ("C", "E", "K" & "H" Body)

Removal ("C", "E", "K" & "H" Body)

  1. Locate orifice tube. See ORIFICE TUBE LOCATION & REMOVER/INSTALLER APPLICATION (GENERAL MOTORS)  table. Discharge A/C system, using approved recovery/recycling equipment. Disconnect liquid line retaining clips.
  2. Disconnect liquid line, at orifice tube location, between evaporator and condenser. Use Dual "O" Ring Joint Separator (J-38042) to hold pressure against liquid line female nut while loosening nut, if necessary. Remove and discard liquid line "O" rings using a nonmetallic tool so seal surface is not damaged.
  3. Remove orifice tube using specified orifice tube remover. See ORIFICE TUBE LOCATION & REMOVER/INSTALLER APPLICATION (GENERAL MOTORS)  table.
scientia non olet · About LEMON Manuals