Removal & Installation (LHS & 300M)
- Traction control switch is located to left of A/C-heater control panel. Disconnect negative battery cable. Remove ashtray if necessary. Using Trim Stick (C-4755), carefully pry center console trim bezel to release retaining clips. Disconnect A/C-heater control panel connectors.
- Open glove box and remove 4 screws from bottom edge of trim bezel in glove box opening. Remove one screw from center console area. Loosen lower right edge then upper right corner of steering column cover.
- Using trim stick, to carefully pry away trim bezel retaining traction control switch. Disconnect traction control switch connector and remove trim bezel. Press tabs together on rear of traction control switch. Push traction control switch through front of trim bezel. To install, reverse removal procedure.