LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1999 >> Sebring Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brakes & Drum Brakes - Except Coupe) >> Bleeding Brake System >> Bleeding Procedures >> Manual Bleeding

Manual Bleeding

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1999 Plymouth Breeze, 1999 Dodge Stratus, 1999 Chrysler Cirrus, 1998 Plymouth Breeze, and 1998 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill master cylinder. Install clear vinyl bleeder hose onto bleed screw at first wheel to be serviced. See BRAKELINE BLEEDING SEQUENCE  . Place other end of hose in clean transparent container.
  2. Partially fill container with clean brake fluid. Submerge end of hose in fluid. Open bleed screw 1-2 turns. Slowly depress brake pedal through its full travel.
  3. Close bleed screw. Release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until brake fluid flows clear and free of bubbles. Proceed to next bleed screw of brake bleeding sequence. See BRAKELINE BLEEDING SEQUENCE  .
NOTE: Check fluid level in master cylinder frequently when bleeding.
scientia non olet · About LEMON Manuals