Power Brake Booster: Installation

NOTE: For models with ABS, a NEW vacuum seal must be installed.

To install, reverse removal procedure. Using Lubriplate, cover surface of brake pedal pin. Use NEW push rod retaining clip. Bleed brakes. See BLEEDING BRAKE SYSTEM . Adjust stoplight switch. See STOPLIGHT SWITCH under ADJUSTMENTS.

Fig 1: Isolating Remote Ground Cable

Courtesy of CHRYSLER CORP.

Fig 2: Locating EGR Valve Transducer

Courtesy of CHRYSLER CORP.

To install, reverse removal procedure. Using Lubriplate, cover surface of brake pedal pin. Use NEW push rod retaining clip and intake manifold gaskets. Bleed brakes. See BLEEDING BRAKE SYSTEM . Adjust stoplight switch. See STOPLIGHT SWITCH under ADJUSTMENTS.