Hazard Warning Switch Test

Remove hazard switch. See HAZARD WARNING LIGHT SWITCH, REAR DEFOGGER SWITCH & REAR WIPER/WASHER SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check continuity between specified switch terminals with switch in appropriate position. See HAZARD WARNING SWITCH RESISTANCE table. See Fig 1 . If continuity is not as specified, replace hazard switch.

HAZARD WARNING SWITCH RESISTANCE

Switch Position

Between Terminals No.

OFF

5 & 7; ⁽¹⁾ 9 & 10

1, 2 & 4; 5 & 6; ⁽¹⁾ 9 & 10

⁽¹⁾	Terminals No. 9 and 10 are switch illumination circuit.

Fig 1: Identifying Hazard Warning Switch Connector Terminals

Courtesy of CHRYSLER CORP.