LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1999 >> Sebring JXi >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brakes & Drum Brakes - Except Coupe) >> Bleeding Brake System >> Bleeding Procedures >> Pressure Bleeding

Pressure Bleeding

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1999 Plymouth Breeze, 1999 Dodge Stratus, 1999 Chrysler Cirrus, 1998 Plymouth Breeze, and 1998 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean master cylinder cap and surrounding area. Remove cap. With pressure bleeder at least half full, connect bleeder to master cylinder using proper adapter(s).
  2. Attach bleeder hose to bleed screw at first wheel to be serviced. See BRAKELINE BLEEDING SEQUENCE  . Place other end of hose in clean transparent container. Partially fill container with clean brake fluid. Submerge end of hose in fluid.
  3. Open release valve on pressure bleeder. Open bleed screw 1-2 turns, noting fluid flow. When flow is clear and free of bubbles, close bleed screw securely.
  4. Repeat procedure for remaining bleed screws in sequence. See BRAKELINE BLEEDING SEQUENCE  . Close release valve on pressure bleeder. Remove pressure tank from master cylinder. Check fluid level of master cylinder reservoir.
scientia non olet · About LEMON Manuals