LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1998 >> Cirrus >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.5L V6 ENGINE - VIN [H] (Except Coupe) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

NOTE: Cylinder bore should be measured at normal room temperature of 70°F (21°C).

Check cylinder bore, out-of-round and taper. Measurements should be taken at approximately .50" (12.7 mm) below top surface of cylinder bore, middle of bore and approximately .50" (12.7 mm) from bottom of cylinder bore. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.

scientia non olet · About LEMON Manuals