LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1997 >> LHS >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Bleeding Brake System >> Bleeding Procedure >> Manual Bleeding

Manual Bleeding

  1. Fill master cylinder (if necessary). Reinstall master cylinder cap. Install clear hose on right rear bleed screw. Place other end of hose in clean, transparent container of brake fluid. Ensure end of clear hose is submerged in brake fluid.
  2. Pump brake pedal 3-4 times. Hold brake pedal downward. Open bleed screw at least one full turn. Brake pedal will drop to the floor. Close bleed screw. Release brake pedal. Repeat bleeding procedure until brake fluid flow is clear and free of bubbles. Bleed remaining brakelines in proper sequence at each wheel. See BRAKELINE BLEEDING SEQUENCE table. Ensure bleed screws are tightened to specification. See TORQUE SPECIFICATIONS  .
BRAKELINE BLEEDING SEQUENCE

Application Sequence
All Models RR, LR, RF, LF
scientia non olet · About LEMON Manuals