LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.5L V6 Engine - VIN [N] - Avenger & SEBRING Coupe >> Removal & Installation >> Intake Manifold >> Removal

Intake Manifold: Removal

NOTE: It is not necessary to disconnect hoses to remove power steering pump and bracket assembly.
  1. Remove right front splash shield. Release fuel pressure. See FUEL PRESSURE RELEASE . Remove air intake hose. Disconnect Throttle Position (TP) sensor and Idle Air Control (IAC) motor connectors. See Figure. Disconnect vacuum hose from throttle body. Remove throttle body assembly. Disconnect power steering oil pressure switch and Heater Oxygen Sensor (HO2S) connectors. Disconnect Intake Air Temperature (IAT) sensor. Disconnect fuel injector connectors on left side of engine.
  2. Remove control wiring harness. Remove accelerator cable. Disconnect vacuum hoses from intake manifold plenum chamber. Disconnect brake booster vacuum hose. Remove Manifold Absolute Pressure (MAP) sensor. Remove EGR pipe. Remove EGR valve and EGR transducer assembly. Remove intake manifold plenum chamber and gasket.
  3. Disconnect fuel supply line from fuel rail. On 1995 models, disconnect fuel return line from fuel rail and fuel pressure regulator vacuum hose. See Figure. On all models, disconnect fuel injector connectors on right side of engine. Remove fuel rail and insulators. Remove power steering pump cover and drive belt. Remove power steering pump and bracket. Suspend power steering pump aside. Disconnect PCV hose. Remove bracket. Remove intake manifold mounting nuts and coned disc spring assembly. Remove intake manifold and gasket.
scientia non olet · About LEMON Manuals