LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - 41TE & 41AE Automatic Transmission >> Testing >> Hydraulic Pressure Tests >> Reverse Clutch Pressure Test

Reverse Clutch Pressure Test

  1. Remove plug and install pressure gauge in reverse clutch pressure tap. See Figure. Place gearshift in Reverse.
  2. Apply brakes. Accelerate until engine speed is 1500 RPM and note reverse clutch pressure. Reverse clutch pressure should be 165-235 psi (11.6-16.5 kg/cm2 ). This pressure test checks reverse clutch hydraulic circuit.
  3. Remove pressure gauge. Install and tighten pressure tap plug to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals