Post-Collision Air Bag Safety Inspection
POST-COLLISION AIR BAG SAFETY INSPECTION
| Action | Components |
|---|---|
| Replace After Deployment | * Air Bag Module(s) * SRS Control Unit |
| Inspect & If Damaged, Replace Component (Even If Air Bag Did Not Deploy) | * Clockspring * Steering Column & Intermediate Joint * Steering Wheel * Wiring Harness |
| Comments | * If any components are damaged or bent, they must be replaced. |
POST-COLLISION AIR BAG SAFETY INSPECTION
| Action | Components |
|---|---|
| Replace After Deployment | * Air Bag Module(s) * Clockspring * Steering Wheel * I/P Plastic Retainer & Steel Reinforcement Assembly * Center Distribution Duct |
| Inspect & If Damaged, Replace Component (Even If Air Bag Did Not Deploy) | * Cluster Hood * Glove Box * Right Trim Bezel * Steering Column Cover * Top Cover |
| Comments | * If any components are damaged or bent, they must be replaced. * After vehicle is repaired, ensure AIR BAG warning light is functioning properly. |
POST-COLLISION AIR BAG SAFETY INSPECTION
| Action | Components |
|---|---|
| Replace After Deployment | * Air Bag Module(s) * Front Impact Sensors * SRS Diagnosis Unit |
| Inspect & If Damaged, Replace Component (Even If Air Bag Did Not Deploy) | * Clockspring * Steering Column & Intermediate Joint * Steering Wheel * Wiring Harness |
| Comments | * If any components are damaged or bent, they must be replaced. |