LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Sebring LXi >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Refrigerant Oil Checking >> Checking Compressor Oil >> NIPPONDENSO 10PA17/10PA17C 10-Cylinder >> Caravan, Town & Country, & Voyager

Caravan, Town & Country, & Voyager

  1. Slowly discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect refrigerant hoses at compressor. Remove compressor bolts and compressor.
  2. Remove suction port on top of compressor, and drain oil. Add proper amount of refrigerant oil to compressor (total system capacity minus amount retained in components that have not been replaced). See 10PA17/10PA17C COMPONENT REFRIGERANT OIL CAPACITIES table. See the REFRIGERANT OIL SPECIFICATIONS tables in the A/C COMPRESSOR SERVICING article for total system capacity.
  3. Install compressor. Evacuate and recharge A/C system. Perform leak test.
10PA17/10PA17C COMPONENT REFRIGERANT OIL CAPACITIES

Component Ounces
Non-Turbo Talon & 2.0L Avenger/Sebring
Compressor (1) 3.4
Condenser 1.4
Evaporator 1.4
Receiver-Drier 0.3
Refrigerant Lines 0.3
Caravan, Town & Country, & Voyager
With Rear Unit
Compressor (1) 7.4
Condenser 1.0
Front Evaporator 2.0
Rear Evaporator 2.0
Receiver-Drier 1.0
Without Rear Unit
Compressor (1) 4.7
Condenser 0.5
Evaporator 1.0
Receiver-Drier 0.5
LH Body & Neon
Compressor (1) 4.75
Condenser 1.0
Evaporator 2.0
Receiver-Drier 1.0
Refrigerant Line 1.5
(1) Add the difference between amount of refrigerant oil in old compressor and the amount specified.