Rear Brake Caliper, Pads & Rotor: Inspection

Replace pads if thickness is less than .08" (2 mm). Measure rotor thickness in 8 or more locations. Replace rotor and pads if rotor thickness is less than .33" (8.4 mm).
To measure rotor runout, tighten rotor to hub with lug nuts. Measure rotor runout at approximately .2" (5 mm) from outer circumference of rotor. If runout is .003" (.08 mm) or more, remove rotor and install with studs in different rotor holes. Remeasure runout. If changing position of rotor on hub does not eliminate runout, replace rotor.