Float Height Measurement
Remove fuel gauge sending unit from fuel tank. Move float to highest point and measure height between point "F" and sending unit cover flange. See Figure . Move float to lowest point and measure height between point "E" and sending unit cover flange. See FLOAT HEIGHT SPECIFICATIONS table. Replace sending unit if readings are not correct.
FLOAT HEIGHT SPECIFICATIONS
| Measure Point | Height | ||
|---|---|---|---|
| AWD | |||
| Main Gauge | |||
| "F" | 7.4-13.4" (.29-.53 mm) | ||
| "E" | 116.5-122.5" (4.58-4.82 mm) | ||
| Sub Gauge | |||
| "F" | 0-6" (0-.24 mm) | ||
| "E" | 123.7-129.7" (4.88-5.12 mm) | ||
| FWD | |||
| "F" | 26.6" (1.05 mm) | ||
| "E" | 159.9" (6.3 mm) | ||