LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1995 >> Cirrus LXi >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (CRUISE CONTROL SYSTEMS - 95 Cirrus & Stratus (VIN X), 96 Breeze, Cirrus & Stratus) >> Self-Diagnostics Tests >> Test TC-35C - No Vehicle Speed Sensor Signal

Test TC-35C - No Vehicle Speed Sensor Signal

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition off. Using scan tool in ohmmeter mode, check resistance on VSS connector ground circuit Black/Light Blue wire. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open VSS ground circuit. Perform TEST VSS-VER - ROAD TEST VERIFICATION .
  2. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for pushed out or damaged terminals. Repair PCM connector as necessary. Perform TEST VSS-VER - ROAD TEST VERIFICATION . If PCM connector is okay, replace PCM. Perform TEST VSS-VER - ROAD TEST VERIFICATION .
scientia non olet · About LEMON Manuals