Test SC-3A - Checking Speed Control Set/Resume Switch
WARNING: This page is about a different variant/trim than selected.
NOTE:
Perform TEST SC-1A - CHECKING SPEED CONTROL OPERATION before proceeding.
- Disconnect 2-pin SET/RESUME switch connector (located behind speed control SET/RESUME switch). Connect a jumper wire between 2-pin speed control SET/RESUME switch connector terminals.
- Turn ignition on. Using scan tool, read speed control switch voltage. If voltage is one volt or more, repair open speed control switch signal circuit Red/Light Green wire. Perform TEST SC-VER - SPEED CONTROL VERIFICATION . If voltage is less than one volt, replace speed control SET/RESUME switch. Perform TEST SC-VER - SPEED CONTROL VERIFICATION .