Turn Signal Switch Continuity Test
Disconnect negative battery cable. Remove upper and lower column covers to gain access to switch connector. Remove switch connector. Using an ohmmeter, test for continuity between terminals of switch. See TURN SIGNAL SWITCH CONTINUITY . See Fig 1 .
TURN SIGNAL SWITCH CONTINUITY
| Position | Continuity | ||
|---|---|---|---|
| Left | 15, 16 & 17 | ||
| Left | 12 & 14 | ||
| Left | (1) 22 & 23 | ||
| Right | 11, 12 & 17 | ||
| Right | 14 & 15 | ||
| Right | (1) 23 & 24 | ||
|
|||