LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1993 >> Imperial >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.3L V6 - VINS [R,T] & 3.8L V6 - VIN [L] >> Removal & Installation >> Timing Chain Cover >> Removal (Dynasty, Fifth Avenue, Imperial & New Yorker)

Removal (Dynasty, Fifth Avenue, Imperial & New Yorker)

  1. Disconnect battery cables. Drain cooling system. Disconnect coolant hoses from timing chain cover. Support engine, and remove right engine mount. Remove oil pan. See OIL PAN  .
  2. Remove oil pick-up tube. Remove transaxle inspection cover (if necessary). Remove right wheel and inner splash shield. Remove drive belts.
    CAUTION: An "O" ring is used on sensor case; if necessary, tap cam sensor lightly to remove. DO NOT pull on wiring harness lead during cam sensor removal.
  3. Remove A/C compressor with hoses attached. Remove A/C compressor mounting bracket. Remove vibration damper. Remove idler pulley from front engine bracket. Remove engine bracket from front of cylinder block. Remove cam sensor from top of timing chain cover.
NOTE: To ensure proper engagement of oil pump on crankshaft, install crankshaft front oil seal after installing timing cover.
scientia non olet · About LEMON Manuals