LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1993 >> Imperial >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Electronic >> Removal & Installation >> Turn Signal Switch R & I >> Removal & Installation (LeBaron Convertible/Coupe)

Removal & Installation (LeBaron Convertible/Coupe)

  1. Disconnect negative battery cable. Remove turn signal switch lever by pulling straight out of switch pod. Remove switch pod assembly. See SWITCH POD R & I  .
  2. Remove 2 turn signal switch retaining screws from bottom of switch pod. Release plastic locking tab on top of turn signal switch. Unplug turn signal switch 7-pin harness connector from headlight switch 14-pin connector. Remove turn signal switch. To install, reverse removal procedure. See SWITCH POD R & I  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals