Instrument Cluster R & I: Installation

1. To install, reverse removal procedure. With instrument cluster installed, route PRNDL shift cable through access hole in base panel.
2. Ensure shift indicator PRNDL actuation cable is properly adjusted. Place gear shift lever in Neutral position. Use Allen wrench to adjust actuation cable adjustment screw to indicate correct gear position in cluster. See Figure . Install remaining lower column cover.

To install, reverse removal procedure. On column shift models, ensure shift indicator PRNDL actuation cable is properly adjusted. Place gear shift lever in Neutral position. Use Allen wrench to adjust actuation cable adjustment screw to indicate correct gear position in cluster. See Figure .