LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1992 >> Imperial >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.3L V6 - VIN [R] & 3.8L V6 - VIN [L] >> Lubrication >> Oil Pump >> Removal & Disassembly

Removal & Disassembly

  1. Remove oil pan. See appropriate OIL PAN. Remove timing chain cover. See TIMING CHAIN COVER  .
  2. To remove pressure relief valve, drill a 1/8" (3.175 mm) hole in relief valve retainer cap. Retainer cap is located at oil pan surface of timing chain cover, near oil pan stud.
  3. Install a self-tapping screw into hole. Clamp screw in a vice. Support timing chain cover while lightly tapping on cover with soft-faced hammer until retainer cap is removed.
  4. Remove spring and pressure relief valve. Remove pump cover bolts and pump cover. Note direction of rotor installation. Remove inner and outer rotors. See Fig 1 .
Fig 1: Oil Pump Components
G90J02584Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals