LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1989 >> Conquest Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VIN [N]] >> Removal & Installation >> Jet Valves >> Inspection & Reassembly

Inspection & Reassembly

  1. Check jet valve head and seat for damage and ensure valve slides smoothly in body. Check that no side play exists. Replace jet valve as an assembly if necessary.
  2. Measure valve stem diameter and face angle. Check jet valve spring free length, out-of-square, and installed height. Replace jet valve as an assembly if not within specification. See VALVES & VALVE SPRINGS  table.
  3. To reassemble, install new stem seal using Seal Installer (MD998308-01). Coat valve stem with oil and install. Ensure valve slides smoothly. Install remaining components.
scientia non olet · About LEMON Manuals