Counterbalance Shafts: Installation
Install new "O" ring on thrust plate. Coat "O" ring with oil. Install guide studs in cylinder block to aid in installation of thrust plate. Ensure shafts are installed in original location. To install, reverse removal procedure.
COUNTERBALANCE SHAFT SPECIFICATIONS
| Application | In. (mm) | ||||
|---|---|---|---|---|---|
| Left Shaft | |||||
| Journal O.D | |||||
| Front | .91 (23.1) | ||||
| Rear | 1.69 (42.9) | ||||
| Oil Clearance | |||||
| Front | .0008-.0024 (.020-.061) | ||||
| Rear | .0037-.0053 (.093-.135) | ||||
| Right Shaft | |||||
| Journal O.D | |||||
| Front | .83 (21.1) | ||||
| Rear | 1.69 (42.9) | ||||
| Oil Clearance (1) | |||||
| Rear | .0037-.0053 (.093-.135) | ||||
|
|||||