LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1989 >> Conquest Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VIN [N]] >> Overhaul >> Rear Crankshaft Oil Seal

Rear Crankshaft Oil Seal

  1. Remove flywheel or drive plate. Remove rear main oil seal case and gasket. Remove oil separator and oil seal from seal case.
  2. To install, coat seal lip with oil. Using Seal Installer (MD998376), install seal in seal case. Install oil separator in seal case with hole of separator located at bottom of seal case at oil pan area.
  3. Install seal case and gasket. Install flywheel or drive plate. Tighten bolts to specification.
scientia non olet · About LEMON Manuals