LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1989 >> Conquest Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VIN [N]] >> Overhaul >> Piston & Rod Assembly >> Fitting Rings

Fitting Rings

NOTE: The No. 1 and No. 2 piston rings use different outer edge cross sections. The No. 1 ring uses a barrel (rounded) type edge, and the No. 2 ring uses a taper type edge. Install each in their proper places.
scientia non olet · About LEMON Manuals