Disc Brake Caliper And Pads - Fwd Models: Installation

Slowly push pistons back into caliper bores until bottomed. Lubricate adapter and guides with multipurpose lubricant. Remove protective paper from noise suppression gasket on pads.
On A.T.E. calipers, install inner pad on caliper while pushing retainer into bore of piston. Install outer pad on adapter and carefully lower caliper over outer pad and rotor.
On Kelsey-Hayes calipers, install inner pad on adapter and install rotor on drive hub. Install outer pad on adapter and carefully lower caliper over pads and rotor.
Install caliper guide pins, using care not to cross threads and tighten. Install hold down spring on A.T.E. calipers. Pump brake pedal several times until a firm pedal is obtained. Refill master cylinder and bleed brake system if necessary.
Install wheel and tire assembly. Tighten lug nuts to 48 ft. lbs. (65 N.m), skipping every other nut while going around. Repeat sequence to full torque. Road test vehicle.