Brake Booster - Fwd Models: Removal
- Remove nuts attaching master cylinder to power brake unit. Remove brake tubes between master cylinder and valve assembly. Remove master cylinder.
- On manual transmission vehicles, remove clutch cable mounting bracket. Pull wiring harness away from and up the strut tower. Disconnect vacuum hose from power brake unit. From under instrument panel position a small screw driver between center tang on retainer clip and pin in brake pedal.
- Rotate screwdriver enough to allow retainer clip center tang to pass over end of brake pedal pin and pull from pin. Discard retainer clip. Remove stoplight switch and striker plate (if equipped). Remove 4 power brake mounting nuts. Remove power brake unit from vehicle.