LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1986 >> Laser XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Master Cylinder >> Disassembly

Master Cylinder: Disassembly

  1. Clean outside of master cylinder. Remove caps or cover/diaphragm assembly. Remove brake fluid level indicator, if used. Pump and drain all brake fluid from master cylinder.
  2. Clamp master cylinder in vise by mounting flange. Remove plastic reservoir and grommets on two piece master cylinders.
  3. Remove push rod, if used. Press primary piston inward and remove stop bolt, if used. Press primary piston inward and remove snap ring. Remove primary piston assembly. Apply compressed air and remove secondary piston assembly.
Fig 1: Typical Cast Iron Tandem Master Cylinder
G27223Courtesy of CHRYSLER MOTORS
scientia non olet · About LEMON Manuals