LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1986 >> Laser XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Brake System Bleeding >> Manual Bleeding

Manual Bleeding

  1. Fill master cylinder. Install bleeder hose to first bleeder valve to be serviced. See BLEEDING SEQUENCE  table. Place other end of hose in clean glass jar partially filled with clean brake fluid so end of hose is submerged in fluid.
  2. Depress brake pedal slowly through its full travel. Open bleeder valve 3/4-1 turn. Close bleeder valve. Release pedal. Repeat procedure until flow of fluid shows no signs of air bubbles.
NOTE: Check fluid level in master cylinder frequently during bleeding to insure air does not enter system.
scientia non olet · About LEMON Manuals