Front Wheel Bearings - RWD Models

Under normal service, front wheel bearings should be inspected, lubricated and adjusted whenever front brakes are serviced or at least every 30,000 miles. For severe service use, check bearings at least every 9000 miles. Lubricate wheel bearings using MOPAR Front Wheel Bearing Grease (High Temperature No. 4318064).

1) Raise and support vehicle. Remove wheel cover, wheel and dust cap. Remove cotter pin and nut lock. Remove brake caliper and support with wire. Tighten adjusting nut to 20-25 ft. lbs. (27-34 N.m) while turning wheel.

2) Stop rotation and back off adjusting nut 1/4 turn (90°) to release preload. Finger tighten adjusting nut while rotating wheel. Position locking nut over adjusting nut, then install cotter pin and dust cover. Adjustment procedure should provide .0001-.0030" (.002-.076 mm) end play.