LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1986 >> Laser Base, 2.2 D, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Column Switches) >> Removal & Installation >> Speed Control Switch >> Installation

Speed Control Switch: Installation

WARNING: This page is about a different car, the 1986 Plymouth Horizon and 1986 Dodge Omni. However, it is still accessible from the selected car via links, so may be relevant.
  1. On all standard columns, insert harness connector through turn signal lever opening in column and pull down and out lower end.
  2. On tilt columns, insert harness wires through turn signal lever opening in column and pull upward through upper housing. Attach guide wire to switch wiring harness and pull gently downward through steering column opening between lock plate and side of housing.
  3. On all models, reconnect wiring harness connector. Install 2 screws to attach speed control switch to column. Push wiper control knob in place. To complete installation, reverse removal procedures.
scientia non olet · About LEMON Manuals