Removal & Installation (Charger, Horizon, Omni & Turismo)

Remove 2 cluster bezel lower attaching screws. Allow cluster to drop slightly and remove from cluster. Remove 4 screws attaching cluster to base panel. Pull cluster rearward and disconnect speedometer cable and wiring. Remove cluster assembly.
To remove fuel gauge and tachometer, remove cluster bezel. Unscrew trip reset knob. Remove mask/lens lower attaching screws. Allow mask/lens to drop slightly and remove. Remove screws attaching gauge to cluster. Remove fuel gauge/tachometer assembly.
To remove the speedometer, remove cluster bezel and mask/lens. Remove screws attaching speedometer to cluster housing. Pull speedometer rearward and disconnect cable.
To remove temperature gauge, oil pressure gauge or voltmeter, remove cluster bezel and mask/lens. Remove screws attaching gauge assembly to cluster. Replace warning lamp bulbs if necessary.
To remove printed circuit, remove cluster assembly. Remove tachometer drive module (if used). Remove lamp sockets and printed circuit board screws. To install components, reverse removal procedure.