LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 1986 >> Laser Base, 2.2 D, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Removal & Installation >> Speedometer, Cluster, Gauges Tachometer & Printed Circuit >> Removal & Installation (Aries, Caravelle, LeBaron, Reliant & 600)

Removal & Installation (Aries, Caravelle, LeBaron, Reliant & 600)

  1. Place gearshift lever in 1st gear. Remove 6 cluster bezel screws. Remove bezel and cluster mask by prying them off clips. Remove rear screws from instrument panel upper pad assembly. Lift rear edge of instrument panel upper pad.
  2. With upper pad raised, remove 2 screws from top of cluster. Remove 2 screws attaching bottom of cluster to panel. Lift rear edge of upper pad and pull cluster rearward. Disconnect wiring and speedometer cable. Remove cluster assembly.
  3. To remove speedometer/odometer assembly, remove cluster bezel and mask. Remove screws attaching speedometer to cluster. On vehicles with cruise control, disconnect speedometer cable at cruise control servo. Pull speedometer rearward and disconnect from cable.
  4. To remove voltmeter, fuel and temperature gauge assembly, remove cluster bezel and mask. Remove screws and gauge assembly from cluster. To remove printed circuit, remove cluster. Remove lamp sockets and attaching screws. To install components, reverse removal procedure.
scientia non olet · About LEMON Manuals