Removal Procedure

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Courtesy of GENERAL MOTORS COMPANY

Disengage the retaining tabs.
Battery Distribution Engine Compartment Fuse Block Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable Nut (1) - Remove [2x]
Engine Wiring Harness Terminal Nut (2) - Remove
Body Wiring Harness Terminal Nut (3) - Remove [4x]
Battery Positive Cable (4) - Remove
Engine Wiring Harness (5) - Remove
Body Wiring Harness (6) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Post Clamp Nut (1) - Loosen
Disengage the retaining tabs.
Battery Distribution Engine Compartment Fuse Block (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery Hold Down Nut (1) - Remove
Battery Hold Down Bolt (2) - Remove
Battery Hold Down Retainer (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery Hold Down Bolt (1) - Remove
Battery Hold Down Retainer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Air Duct Retainer (1) - Remove [2x]
Release the 2 retainer tabs (arrows) to remove the intake air duct.
Courtesy of GENERAL MOTORS COMPANY

Intake Air Duct (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Wastegate Actuator Vacuum Control Solenoid Valve Filter Hose (1) @ Air Cleaner Assembly (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Disconnect
Wiring Harness Retainer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Clamp (1) - Loosen
Air Cleaner Outlet Front Duct (2) @ Air Cleaner Assembly (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Assembly (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery Tray Bolt (1) - Remove [4x]
Disconnect any harness retainers attached to the battery tray.
Battery Tray (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Battery Tray Bracket Bolt (1) - Remove [2x]
Battery Tray Bracket Nut (2) - Remove
Disconnect any harness retainers attached to the battery tray bracket.
Battery Tray Bracket (3) - Remove
Raise and support the vehicle. Lifting and Jacking the Vehicle .
Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Front Brake Pipe Fitting (1) @ Brake Pressure Modulator Valve - Remove
Plug the brake pressure modulator valve port to prevent brake fluid loss and contamination.
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Front Brake Pipe Fitting (1) @ Front Brake Hose (3) - Remove
Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Front Brake Hose Retainer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Pressure Modulator Valve Front Brake Pipe Clip (1) - Release
Brake Pressure Modulator Valve Front Brake Pipe (2) @ Vehicle - Remove