Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
- Clean all dirt and foreign material from the brake hose ends and the brake pipe fitting.
Rear Brake Pipe Fitting (1) @ Rear Brake Hose (3) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Rear Brake Hose Retainer (2) - Remove
Rear Brake Hose Fitting Bolt (1) @ Rear Brake Caliper - Remove
- Rear Brake Hose (2) @ Rear Brake Caliper - Remove
- Rear Brake Hose Washer (3) - Remove and DISCARD [2x]
These washers may be stuck to the brake caliper and/or the brake hose end.